1 出現換擋錯誤甚至發動機熄火：可能是開/關電磁閥N92 (多路轉換閥)失效。
1. Shift error or even engine shutdown: the on / off solenoid valve n92 (multiplexer valve) may fail.
2 變速器離合器K1或K2的擋位無法實現，組合儀表上會有故障顯示：可能是壓力控制閥N215或壓力控制閥N216失效。
2 if the gear of transmission clutch K1 or K2 cannot be realized, there will be a fault display on the combination instrument: it may be the failure of pressure control valve n215 or pressure control valve n216.
3 系統以油壓工作，油耗上升，換擋噪聲大：可能是主油壓控制閥N217失效。
3. The system works with the maximum oil pressure, the oil consumption increases and the shift noise is large: it may be that the main oil pressure control valve n217 fails.
4 低溫下出現換擋困難，油耗也會增加：可能是離合器冷卻壓力控制閥N218失效。
4 it is difficult to shift gears at low temperature, and the fuel consumption will also increase: it may be that the clutch cooling pressure control valve n218 fails.
5 變速器只能以2擋行駛：可能是安全閥控制電磁閥N233失效、輸入軸轉速傳感器1G501失效或者液壓傳感器G193失效。
5. The transmission can only drive in second gear: the safety valve control solenoid valve n233 may fail, the input shaft speed sensor 1g501 may fail, or the hydraulic sensor g193 may fail.
6 變速器只能以1擋和3擋行駛：可能是安全閥控制電磁閥N371失效、輸入軸轉速傳感器2G502或液壓傳感器G194失效。
6 the transmission can only be driven in 1st and 3rd gears: the safety valve control solenoid valve n371 may fail, the input shaft speed sensor 2g502 or the hydraulic sensor g194 may fail.
Today, Xiaobian presents you the relevant knowledge about Jinan automatic transmission maintenance. If you have any questions and questions about this article, please call us or leave a message below the website: http://m.566605.com
